E6581595
F-8
6
Explanation of the coast stop function
When ST (Standby) is OFF, coast stops.
The default setting for ST (Standby) is ON, change the
following settings.
(no function)
Assign open input terminal 6: ST (Standby).
Coast stops if terminal set for ST (Standby) is set to
OFF. The monitor on the inverter at this time displays
Motor
speed
ON
OFF
ON
OFF
F-CC
ST-CC
Coast stop
6.3.3
Modifying input terminal functions
: Input terminal selection 1A (F)
: Input terminal selection 2A (R)
: Input terminal selection 3A (S1)
: Input terminal selection 4A (S2)
: Analog/logic input selection (VI
Terminal)
: Input terminal selection 5 (VI)
: Input terminal selection 1B (F)
: Input terminal selection 2B (R)
: Input terminal selection 3B (S1)
: Input terminal selection 4B (S2)
: Input terminal selection 1C (F)
: Input terminal selection 2C (R)
Refer to section 7.2.1 for details about input terminal functions.
6.3.4
Modifying output terminal functions
: Output terminal selection 1A (OUT)
: Output terminal selection 2 (FL)
: Output terminal selection 1B (OUT)
: Output terminal logic selection (OUT)
Refer to section 7.2.2 for details about output terminal functions.
