E6581595
D-11
4
Default setting 1 (
=
)
Setting
to
will return parameters to the standard values that were programmed at the factory.
When
is set,
is displayed for a short time after the settings are configured, and then
disappears. Then the inverter is in standard motor mode. In this case, the trip history data is cleared.
Trip record clear (
=
)
Setting
to
initializes the past four sets of recorded error history data.
The parameter does not change.
Cumulative operation time clear (
=
)
Setting
to
resets the cumulative operation time to the initial value (zero).
Initialization of type information (
=
)
Setting
typ
to
clears the trips when an
format error occurs. But if the
displayed, call us.
Save user setting parameters (
=
)
Setting
to
saves the current settings of all parameters. (Refer to section 4.2.7)
Load user setting parameters (
=
)
Setting
to
loads parameter settings to (calls up) those saved by setting
to
.
(Refer to section 4.2.7)
By setting
to
or
, you can use parameters as your own default parameters.
Cumulative fan operation time record clear (
=
)
Setting
to
resets the cumulative operation time to the initial value (zero).
Set this parameter when replacing the cooling fan, and so on
Default setting 2 (
=
1
)
Set
to
to return all parameters to their default settings.
When
is set,
is displayed for a short time after the settings are configured, and then
disappears. Then setup menu
is displayed. After reviewing the setup menu items, make a setup
menu selection. In this case, all parameters are returned to their defaults, and the trip history data is cleared.
(Refer to section 3.1.)
Be aware that the following parameters do not return to the standard factory settings even if
=
is set
for maintainability. (To initialize all parameters, set
=
.)
: Meter selection
: Logic output/pulse train output
: Meter adjustment gain
selection (OUT-NO)
: Checking the region setting
: Analog output signal selection
: Analog/logic input selection (VI terminal)
:
Inclination characteristic of analog output
: Sink/source switching
: Analog output bias
: VI input bias
: Factory specific coefficient 6D
: VI nput gain
: Free notes
