E6581595
E-5
5
5.3 Setting
acceleration/deceleration time
5.3.1 Automatic
acceleration/deceleration
：
Automatic acceleration/deceleration
Function
This automatically adjusts acceleration and deceleration time in line with load.
Refer to section 5.3.2 for setting acceleration/ deceleration time manually.
=
* Adjusts the acceleration/deceleration time automatically within the range of 1/8 to 8 times as long as the time
set with the
or
, depending on the current rating of the inverter.
=
* Automatically adjusts speed during acceleration only. During deceleration, speed is not adjusted
automatically but reduced at the rate set with
.
Set
(automatic acceleration/deceleration) to
or
.
[Parameter setting]
Title
Function
Adjustment range
Default setting
Automatic acceleration/deceleration
0: Disabled (manual setting)
1: Automatic
2: Automatic (only at acceleration)
0
When automatically setting acceleration/deceleration time, always change the acceleration/deceleration time
so that it conforms to the load. For inverters that require a fixed acceleration/deceleration time, use the
manual settings (
,
).
Setting acceleration/deceleration time (
,
) in conformance with mean load allows optimum setting
that conforms to further changes in load.
Use this parameter after actually connecting the motor.
When the inverter is used with a load that fluctuates considerably, it may fail to adjust the acceleration or
deceleration time in time, and therefore may be tripped.
Do not use
=
when using a brake module (optional).
Output
frequency (Hz)
Deceleration
ti
Acceleration
ti
Example in case the acceleration
and deceleration time become short
Time
[
]
0
Deceleration
Acceleration
Output
frequency (Hz)
Time
[
]
0
Example in case the acceleration
and deceleration time become long
