E6582233
F-10
6
Setting of switching terminals
To switch to motor 2, assign the following functions to a terminal not being used. It is also possible to switch
to acceleration/deceleration 2 (AD2). Refer to section 6.17.1 for details.
It is possible to set 3 functions for terminal F and R, and 2 functions for terminal S1 and S2.
Input terminal function number
Parameters changed from applicable parameters and
default standards
24
AD2
28
VF2
32
OCS2
OFF OFF OFF
Standard default:
,
,
,
,
,
,
,
,
ON OFF OFF
→
,
→
,
→
OFF ON OFF
→
V/F constant ,
→
,
→
,
→
,
→
OFF OFF ON
→
Note 1: Each of the following numbers (25, 29, 33) are reverse signals.
Note 2: Switching from "V/F constant" to
=
to
cannot be done while running. Stop the motor before
changing.
Note 3: Integral value of motor electronic thermal is cleared, after the motor switching.
However, the setting that can memorize an integral value is possible.
Example of setting a terminal for switching : Sink logic
F (F: Forward run)
CC
S2(VF2)
R(OCS2)
S1(AD2)
Forward run command
2nd acceleration/deceleration switch
2nd stall prevention operation switch
2nd V/F setting switch
