E6582233
D-11
4
Default setting 1 (
=
)
Setting
to
will return parameters to the standard values that were programmed at the factory.
☆
When
is set,
is displayed for a short time after the settings are configured, and then
disappears. Then the inverter is in standard motor mode. In this case, the trip history data is cleared.
Trip record clear (
=
)
Setting
to
initializes the past four sets of recorded error history data.
☆
The parameter does not change.
Cumulative operation time clear (
=
)
Setting
to
resets the cumulative operation time to the initial value (zero).
Initialization of type information (
=
)
Setting
typ
to
clears the trips when an
format error occurs. But if the
displayed, call us.
Save user setting parameters (
=
)
Setting
to
saves the current settings of all parameters.
Load user setting parameters (
=
)
Setting
to
loads parameter settings to (calls up) those saved by setting
to
.
☆
By setting
to
or
, you can use parameters as your own default parameters.
Cumulative fan operation time record clear (
=
)
Setting
to
resets the cumulative operation time to the initial value (zero).
Set this parameter when replacing the cooling fan, and so on
Number of starting clear (
=
)
Setting
to
12
resets the number of starting to the initial value (zero).
Be aware that the following parameters do not return to the standard factory settings even if
=
is set
for maintainability.
: Meter selection
: Analog output signal selection
: Meter adjustment gain
:
Inclination characteristic of analog output
: Analog/logic input selection (VI terminal)
: Analog output bias
: Sink/source switching
: Factory specific coefficient 6D
: VI input bias
: Free notes
: VI nput gain
: Logic output/pulse train output selection (OUT-NO)
