5
4. Receipt Roll
Paper type
Thermal paper rolled with the print side facing outside
Width (W1)
80 +/ -1.0 mm
Width (W2)
58 +0/ -1.0 mm (With optional 58 mm paper guide)
Outer diameter (D)
76 +/-2.0 mm
Paper thickness (T)
0.065 +/- 0.005 mm
Weight 53
g/m
2
Outer core diameter
21.5 mm
Inner core diameter
12.5 +/- 0.5 mm
Recommended thermal
paper
Only paper rolled onto a core is acceptable, however, the
paper end should not be pasted to the core. TOSHIBA
TEC recommends using the following thermal paper for
this product.
Manufacturer : OJI
Type : JFD210
CAUTION!
Use only paper which meets specified requirements. Use of non-specified paper may
shorten the head life of the printer, resulting in problems with print quality, cause a paper
feed failure or shorten the cutter life. All paper should be handled with care to avoid any
damage to the paper. Read the following guideline carefully.
•
Do not store the paper for longer than the manufacturer’s recommended shelf life.
•
Store the paper in a cool, dry place. Avoid areas where they would be exposed to direct
sunlight, high temperature, high humidity, dust or gas.
•
A contact of chemical or oil may discolor or erase the printed record.
•
Rubbing the paper hard with nail or hard object may discolor the paper.
•
The paper end should not be pasted to the core.
For further information please contact your authorized TOSHIBA TEC representative or
authorized paper manufacturer.
W1 or W2
