BACK IO”
12”
6.
7.
8.
9.
0
6
II
-
9
7
‘
-
8
0
0
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
3
0
0
VIDEO IN OUT CONNECTOR
Connector to the video output of a VCR or another monitor (for loop-through
connection) or to a video camera.
Loop-through output of the VIDEO IN connector Connector the video input of
another monitor or a VCR.
Note: The impedance is automatically set to 75 ohm by the input of a signal on the
input connector while operating in a single connection mode. However, if a cable
is connected to the output connector, the connection is placed into the open
status by the multiple connection and high impedance automatically selected.
Caution: Do not leave an unused cable connected to the monitor. If a single cable is
used, then it must be connected to the input connector for the 75 ohm
termination selector to function properly
SCAN MODE SELECTOR (EIA
CCIR)
Set to EIA
for
EIA standard.
Set to
for
standard.
V-HEIGHT CONTROL
To adjust this control for the vertical size of the picture.
V-LIN. CONTROL
To adjust this control for the vertical linearity of the picture.
