INSTALLATION
Installation
Before installing the machine, the location characterized
as follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0
°
C
5.Keep far away from the heat resources such as coal or gas.
Please take the following steps to remove the bolts:
1.Loosen 9 bolts with spanner and then remove them.
2.Cover the hole with transport hole plugs.
3.Keep the transport bolts properly for future use.
Installthe rat resistance panel &Remove transport bolts
• Stability is important to prevent the product from
wandering!
• Make sure that the product should not stand on
the power cord.
Warning!
• You must remove the transport bolts from the backside before using the product.
• You’ll need the transport bolts again if you move the product , so make sure
you keep them in a safe place.
Warning!
w
w
W
>
20mm
Installation area
12
Install the rat resistance panel
Remove transport bolts (9unites)
Screwed the rat resistance panel
to the bottom of machine