Q9 Plus ASD Installation and Operation Manual
33
Remote Mounting without the Mounting Kit
Note:
See
Figure 27
for the dimensions and the item locations referenced in steps 1 – 7.
1.
At the
EOI
mounting location, mark the 3.80” by 3.56” hole and the four 7/32” screw holes.
2.
Cut the 3.80” by 3.56” rectangular mounting hole.
3.
Drill the four 7/32” screw holes.
4.
Remove the
Front Panel Assembly
of the ASD — using a flathead screwdriver, release the upper
retaining tabs of the EOI panel. Then pivot the EOI assembly away from the ASD and lift
(see
Figure
26
).
5.
Remove the
EOI
from the
Front Panel Assembly
of step 4 — discard the assembly.
6.
Attach and secure the
EOI
to the front side of the mounting location using the four 6-32 x 5/16” pan
head screws, the #6 split lock washers, and the #6 flat washers.
7.
Install the
Front Panel Connector Assembly
to the ASD (see
Figure 26
).
8.
Connect the
Extender Cable
from the
EOI
to the
Front Panel Assembly
.
Figure 27. EOI Remote Mounting Dimensions (inches/millimeters).
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
