75
11
button (Unit/Louver select button)
Used for selecting a unit while changing settings if
the remote controls two or more units.
UNIT button:
If two or more indoor units are controlled by one
remote controller, use this button to select a unit to
adjust its air blow direction.
LOUVER button (*1):
(4-way cassette type 2H
series only)
Selects a louver to control when adjusting the
louver lock setting or wind direction setting
separately for each louver.
12
button (Temperature set button)
Adjusts the set temperature.
Select the desired set point by pushing TEMP.
or TEMP.
13
button (Ventilation fan speed button)
Used to select the ventilation fan speed.
You can stop 24-hour ventilation temporarily by
pressing and holding the button for 4 seconds
while
is displayed.
14
button (Ventilation mode button)
Used to select a ventilation mode.
15
button (Filter elevating button) (*1)
* This function is not available.
OPTION:
Remote controller sensor (*1)
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
* Do not use the function when the air conditioner is
controlled in a group.
(*1):
This function is not available for Air to Air Heat
Exchanger.
“
” will be displayed for few seconds when the unit is
running in a system equipped with only the Air to Air
Heat Exchanger.
13
14
15
12
11
UNIT LOUVER
Summary of Contents for VN-M1000HE
Page 150: ......
