32
https://www.toshiba.com/tic/
System Configuration and Menu Options
W7B ASD Installation & Operation Manual
System Configuration and
Menu Options
Root Menus
The MON/PRG key is used to access the three root
menus of the W7B ASD: the Frequency Command
screen, the Monitor screen, and the Program
screen. From either mode, press the MON/PRG key
to loop through to the other modes (see
).
In the event of a fault, the ASD displays the fault
screen and provides an on-screen indication of the
fault type. The Fault screen remains in the MON/
PRG screen rotation (see
) until the
source of the fault is removed and the ASD is reset.
Figure 23. Root Menu Mapping.
Frequency Command Screen
Frequency Setting
While operating in the Hand mode (Hand LED is
illuminated on the EOI), the running frequency of
the motor may be set from the Frequency
Command screen. Using the Rotary Encoder, enter
the desired Frequency Command value, press the
Enter key and then press the RUN key. The motor
will run at the Frequency Command speed and may
be changed while running. The Frequency
Command screen is not displayed during an active
trip.
Figure 24. Frequency Command Screen.
The Panel Menu screen provides easy access to
the most common setup parameters. Panel Menu
changes will affect EOI-controlled ASD operation
only and is accessed by pressing the ESC key from
the Frequency Command screen.
Commanded Speed
in the Local Mode
Running Speed
Operating Mode
User−Selectable Monitored
Items
{
{
{
{
Alarm Display
Section (Under−
Current Alarm
Example Displayed)
Summary of Contents for W7 DN-57442-006
