Toshiba WX9 ASD Installation & Operation Manual Download

Page: 47 / 226

WX9 ASD Installation and Operation Manual

EOI Remote Mounting

The

WX9 ASD

may be controlled from a remotely mounted EOI. For safety and application-specific

reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or
that the

EOI

not be attached to the ASD housing. The

EOI

may be mounted either with or without the

optional

Remote Mounting Kit

(P/N ASD-MTG-KITQ9), which allows for remote

EOI

placement and

easier cable routing.

The

EOI

can operate up to 9 feet away from the ASD. An

EOI

extender cable is required for remote

mounting and is included with

Remote Mounting Kit

or can be ordered through the TIC Customer

Support Center.

Remote Mounting Hardware

•

Remote Mounting Kit (optional) — P/N ASD-MTG-KITQ9

•

LCD Cable, 9 ft. — P/N 76268

Remote Mounting Installation Precautions

Install the unit securely in a well-ventilated area that is out of direct sunlight. The ambient temperature
rating for the display module is 14° to 104° F (-10° to 40° C).

•

Select a mounting location that is easily accessible by the user.

•

Avoid installation in areas where vibration, heat, humidity, dust, metal particles, or high levels or
electrical noise (EMI) are present.

•

DO NOT

install the unit where it may be exposed to flammable chemicals or gases, water, solvents,

or other fluids.

•

Turn on the power only after securing the front cover of the ASD.

Remote Mounting Using the Mounting Kit

Note:

See

Figure 25 on pg. 36

for the dimensions and the item locations referenced in steps

1 – 7.

1. At the

EOI

mounting location, mark the 4.60” by 4.50” hole and the four 11/32” screw holes.

2. Cut the 4.60” by 4.50” rectangular mounting hole.

3. Drill the four 11/32” screw holes for the

Bezel Plate

mount.

4. Attach and secure the

Bezel Plate

to the front side of the mounting location using the four 10-32 hex

nuts, #10 split lock washers, and the #10 flat washers.

5. Remove the

Front Panel Assembly

of the ASD — using a flathead screwdriver, release the upper

retaining tabs of the EOI panel. Then pivot the EOI assembly away from the ASD and lift

(see

Figure

26 on pg. 36

6. Remove the

Display Module

from the

Front Panel Assembly

of step 5 — discard the assembly.

7. Attach and secure the

Display Module

to the front side of the

Bezel Plate

using the four 6-32 x



5/16” pan head screws, and the #6 split lock washers.

When installing the

Display Module

into the

Bezel Plate

, ensure that the left side of the display is

inserted first with the top and bottom catches securely in place (adjacent to the Phillips screws at
underside of display). This ensures the proper alignment and electrical connection of the CNX
connector of the

Display Module

PCB. Then gently hold the display in place while securing the

Phillips mounting screw.

8. Install the

Front Panel Connector Assembly

to the ASD (see

Figure 26 on pg. 36

9. Connect the

Extender Cable

from the

EOI

to the