90
WX9 ASD Installation and Operation Manual
OUT2 On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
OUT2
(
A
&
C
) output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F151
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
FL On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
FL
output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F152
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT4 On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
OUT4
output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F153
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT5 On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
OUT5
output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F154
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT6 On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
OUT6
output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F155
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT7 On Delay
Program
Terminal
Output Terminal Delays
This parameter delays the closing of the
OUT7
output terminals by the
programmed value (see waveforms at
).
The delay may be increased to prevent relay chatter.
Direct Access Number — F156
Parameter Type —
Numerical
Factory Default —
2.0
Changeable During Run —
No
Minimum — 2.0
Maximum — 200.0
Units — mS
Summary of Contents for WX9 ASD
