9
Table of Contents
4. TosIboX
®
Key and loCK serIalIzaTIon
The instructions below can be further clarified
by seeing the accompanying diagram on the
following page.
1. Connect the TOSIBOX
®
AC adapter to the
Lock and wait for 2 minutes. Serialize the
Key to the Lock by inserting the Key into
the USB port of the Lock. When the LED
on the Key stops blinking, the serialization
is complete (approximately 10 seconds).
Remove the Key from the Lock. You can
also serialize additional Locks to the same
Key. After the first Key is serialized to the
Lock, the subsequent Keys (Sub Keys) are
serialized with a computer. See section
”Multiple Keys, p.20”. Please see the
accompanying image on the next page.
2 - 3. Connect the Lock to your network
according to your use case. See section
Deploying the Lock (p.11.). Remember
to make sure that the Lock has a working
internet connection.
4. Connect the Key to your computer and
install the Key software. Follow the section
”Deploying the Key”.
5. The TOSIBOX
®
connection is now ready
to be used to control and monitor remote
devices.
