P. 1 8
Fixing Improper Rolled up Screen
●
When a screen is not rolled up properly, it may cause damages to the screen or the product.
TOSO Roller Blinds are inspected and adjusted to operate properly when delivered, however
if a roller blind rolls improperly, follow below instruction.
<What is Improper Rolling?>
1) Screen edge is misaligned.
2) Screen edge touches a side holder.
3) Weight Bar is not horizontal.
■
How to fix improper rolling?
(1) Make sure a product is installed correctly.
1) Is a product installed horizontally?
2) Are Brackets placed at correct at position?
* Reinstall the product if it is not installed properly.
(2)Slowly operate Ball Chain and pull down the
screen to the bottom, then once again roll up
the screen.
(3)Repeat the instruction (2) for 2-3 times.
1)
Install horizontally
1)
3)
2)
2)
Brackets are
placed in
correct
positions
(Refer to P.6,
P.8 and
P.11.)
Troubleshooting
Cleaning
●
For regular care, dust with a feather duster or a hand mop.
●
To avoid discoloration, avoid cleaning the screen with water or using it in a location
susceptible to splashing water.
Do not disassemble or modify the mechanism inside Roller Pipe.
Caution
Phenomenon
Actions
●
When the screen does not stop at the
desired height, and rolls down.
●
When the screen does not stop at the
desired height, and rolls up.
●
When Ball Chain is pulled, it does not
operate smoothly with an unusual noise, or
does not operate at all.
●
When the screen does not descend
●
Repeatedly carry out the adjustment
described in “Lighter roll up” on P.16 or
P.17.
●
Repeatedly carry out the adjustment
described in “Heavier roll up” on P.16 or
P.17.
●
It is likely that the position of Ball Chain
Cover is incorrect. Carry out the proce-
dure set out on P.10.
●
It is likely that this is because the dial of
Side Holder is not fully in the “CLOSE”
condition.
Turn the dial in the “CLOSE” direction
until it stops completely.
P. 1 9
