P. 1 0
5) Install the screen on the opposite side the
chain. Fit the hole in the roll screen body
over Link Joint Pin protruding from Link
Bracket.
* In the case of three links, repeat the work of
steps 4) and 5).
* Install the screens as of they are the same height.
6) Install the black knob on the roll screen body to
Side Holder (left side) to ensure that the red
part is visible at the front. Once the screen is
correctly in place, turn the dial in the “CLOSE”
direction until it clicks.
7) Set Ball Chain cover at the top.
* Push the tab on the ball chain cover to the side
opposite the screen, and while keeping it pressed,
turn the cover through 90°.
<Ceiling Attachment>
<Wall Attachment>
Ball chain cover
Ball chain cover
(4)Finally, open and close the screen two or three
times, and check their operation.
(5)How to remove the screen
1) Pull down the screen 5 and 10 cm and stop
it.
2) Rotate the dial of Side Holder on the oppo-
site side the chain until it stops in the “OPEN”
direction.
3) Remove a roll screen body slowly with both
hands. Remove the cover and Link Joint Pin
of the link section, and then remove the
screen, while taking care that neither the
screen nor the chain drops.
Push this tab to the opposite side
the screen, and while keeping it pressed,
turn the cover through 90°.
P. 11
(1)Determine the installation locations of the
brackets so that the distance between the
brackets is the same as the width of the product
that you ordered. The direction of each Link
Bracket is shown below.
(2)Mount End Side Brackets with screws.
If you install the brackets while they are bent,
the screens are liable to move sluggishly or
drop off.
Installation and Detachment of a Link Double Type
One
Side
Operation
Both
Sides
Operation
2 Units Link
3 Units Link
W2
W1
Use fixing screws that are suitable for
the strength and the material of the wall
or window frame to which the brackets
are to be fixed.
Be sure to install each Side Holder
using at least two fixing screws.
Caution
Wall Attachment
Ceiling
Attachment
W2
W1
W2
W3
W1
W2
W1
W2
W3
W1
