P. 1 2
(3)Install the screen.
* The method of lowering the roll screen on the
window side differs from that of the roll screen on
the room side.
* The figure shows an one-sided operation (right).
Install the screen from the chain side.
Use the following sequence otherwise
you will be unable to install the screen.
Caution
1)Remove the cover of each Link Double
Bracket (other than Side Brackets at both
ends) on both the chain side and the side
opposite it.
Link Double Bracket
2) Pull down the screen 5 to 10 cm, then set the
chain as the position of Chain Connector is
located on the rear side, then attach Chain
Connector is about 3 cm below Bottom Bar.
The direction of the chain which of the
screen installed on the room side is the
opposite of the above.
3)Insert the dowel (transparent) at the end of
the screen into Side Holder on the chain
side.
* Do not install some screens at once.
* The position of Side Holder on the chain side
differs depending upon the operating position.
5-10cm
About 3cm
Chain
Connector
Chain
Connector
About 3cm
5-10cm
Cover
Room side
Room side
Window side
Window side
Chain side
Side Holder on the
chain side
Bottom Bar
P. 1 3
4) While holding the screen, insert Link Joint Pin
into Link Bracket, and then pass it through
the hole in the roll screen body side. Once
you have inserted Link Joint Pin to the rear,
install the cover while rotating it.
* After installing the cover, check to see if it has
been tightened securely.
* Do not install some screens at once.
Insert Link Joint
Pin into the hole.
5 ) Remove the screen on the side opposite the
chain. Fit the hole in the roll screen body
over Link Joint Pin protruding from Link
Double Bracket.
* In the case of three links, repeat the work of
steps 4) and 5).
* Install the screens as of they are the same height.
6) Install the black knob on the roll screen body
onto Side Holder on the opposite side the
chain as the red part can be seen at the front.
Once the screen is correctly in place, turn the
dial in the “CLOSE” direction until it clicks.
*
Check to see if Roller Pipes are parallel to
each other.
(4) Finally, open and close the screen two or three
times, and check their operation.
After inserting the dowel,
rotate the dial.
Link Joint Pin
Insert Link Joint Pin.
