P. 1 0
How to Operate
<Mytec 01 Loop>
<Mytec 01>
To operate the blind, grasp the pull ball with your hand, and move it in the vertical
direction. Be sure to set the pull ball at the center of Weight Bar. If the pull ball does
not coincide with the center, or if you move it obliquely, trouble is likely to occur.
■
How to close a screen
●
By pulling the pull ball directly downward and then
releasing it, the screen will stop at that position.
■
How to open a scresn
●
By pulling down the pull ball a distance of about 5
to 6 cm and then releasing it, the screen will rise.
* If you pull down the screen hard, for example, the screen is likely to
overrun, and may fail to rise again. In such a case, turning Roller
Pipe slightly by hand will enable the screen to be rolled up.
* When the room temperature is low, such as during winter, the speed
at which the screen rises may slow down. Please note, however,
that this does not mean that the blind is broken.
Turn by hand
Roller
Pipe
Screen
Caution
Caution
Make sure to pull Ball Chain slowly when using the product. If Ball Chain is pulled quickly,
the product may not roll up properly.
Please do not hang from the screen or the ball chain. The product may fall down.
■
How to close a screen
●
Pull the back side of Ball Chain downward.
■
How to open a screen
●
Pull the front side of Ball Chain downward.
Fixing over run
Pull ball
Pull ball
Pull
Pull
P. 11
■
How to adjust the stop position
(1)First, set the screen in the fully rolled up con-
dition.
(2)Turn the dial of the stop controller on Side
Holder (right side) to the rear, and lower the
screen to the desired height. Turning the dial
toward you causes the screen to rise.
(3)Pull the pull ball, and open and close the
screen several times. If the stop position is
incorrect, carry out fine adjustment by turning
the dial.
Do not raise and lower the screen by turning the screen or Roller Pipe because
this may damage the blind.
Caution
●
Stop Controller is optional parts and it can be stopped at a predetermined height. Use this
function when you wish to stop the screens of connected windows at the same height, for
example.
<Ceiling Attachment>
<Wall Attachment>
Lower the screen
Stop controller dial
Raise the screen
How to Use a Stop Controller (Optional)/Mytec 01 Only
