P. 1 4
Fixing Improper Rolled up Screen
●
When a screen is not rolled up properly, it may cause damages to the screen or the product.
TOSO Roller Blinds are inspected and adjusted to operate properly when delivered, however
if a roller blind rolls improperly, follow below instruction.
<What is Improper Rolling?>
1) Screen edge is misaligned.
2) Screen edge touches a side holder.
3) Weight Bar is not horizontal.
■
How to fix improper rolling?
(1) Make sure a product is installed correctly.
1) Is a product installed horizontally?
2) Are Brackets placed at correct at position?
3) Has the pull ball been set at the center of
Weight Bar? (In the case of Mytec 01)
* Reinstall the product if it is not installed properly.
(2)In the case of Mytec 01 Loop, pull Ball Chain
slowly so as to lower the screen to the bottom and
stop it there, then roll up the screen once again.
In the case of Mytec 01, pull the pull ball vertically
downward so as to lower the screen to the bottom
and stop it there, then pull down the screen by a
further 3 to 4 cm and release it so that it rises
again.
(3)Repeat the instruction (2) for 2-3 times.
Pull the pull ball
vertically
1)
Install horizontally
1)
3)
2)
2)
Brackets are
placed in
correct
positions
(Refer to P.9)
3)
Set the pull ball at the center of
the weight bar (Refer to P.8)
P. 1 5
Troubleshooting
Cleaning
●
For regular care, dust with a feather duster or a hand mop.
●
To avoid discoloration, avoid cleaning the screen with water or using it in a location
susceptible to splashing water.
Mytec 01 Loop
Mytec 01
Common
Do not disassemble or modify the mechanism inside Roller Pipe.
Caution
Phenomenon
Model
Actions
●
When the screen does not stop
at the desired height, and rolls
down.
●
When the screen does not stop
at the desired height, and rolls
up.
●
When Ball Chain is pulled, it
does not operate smoothly with
an unusual noise, or does not
operate at all.
●
When the screen does not roll
up, or when the roll-up speed
is very low.
●
When the screen does not
descend
●
Adjust the operating force by repeat-
edly carrying out the procedure
described in “Lighter roll up” under
<Mytec 01 Loop> on P.12.
●
Adjust the operating force by repeat-
edly carrying out the procedure
described in “Heavier roll up” under
<Mytec 01 Loop> on P.12.
●
It is likely that the position of
Ball Chain Cover is incorrect.
Carry out the procedure set
out on P.7 or P.8.
●
Repeatedly carry out the adjust-
ment procedure described in
“Faster roll up” under <Mytec 01>
on P.13.
●
It is likely that this is because
the dial of Side Holder is not
fully in the “CLOSE” condition.
Turn the dial in the “CLOSE”
direction until it stops
completely.