OPERATION AND STORAGE
TO TURN ON THE HEATER
1. Open the cylinder valve after checking that the connections are all tight and that there
are no gas leaks
2. Press in and then turn the appliance control valve knob in an anti clockwise direction to
the Pilot position
3. With the appliance control valve in the Pilot position continue to press the control valve
knob in and whilst doing so press the ignitor button several times until the Pilot burner
ignites. Once the pilot burner has ignited release the control knob
Note:
If a new cylinder has been fitted it may take a minute for the air in the hose to be cleared
before the pilot burner ignites.
If the pilot burner does not ignite repeat Step 3
4. After the Pilot Burner ignites turn the appliance control valve to the full position and
leave it at that setting for 5 minutes before turning the knob to the desired heat setting
TO TURN OFF THE HEATER
1. Press and turn the appliance control knob to the Off position
2. Close the cylinder valve
1. Always close the cylinder valve when the heater is not in use, or if the heater
malfunctions when in use,or if there is a gas leak.
2. Store the cylinder in cool dry well ventilated place away from any other flammable
materials
3. Protect the heater from damage by covering it when not in use.
Off- Shut down position
Hi - Max temperature setting
Lo - Min temperature setting
Variable control knob
Pointer
LO
W
H
IG
H
T
O
LI
P
OFF
IG
N
IT
E
P
us
h
to
tur
n
- 6 -
