10
ASSEMBL
Y & INST
ALL
TOTAL GYM
®
JUMP TRAINER
TM
OWNER’S GUIDE |
ASSEMBLY & INSTALLATION
STEP 8.
Using the hardware (D, C) as
indicated; attach the Rear Base to the
Rear Struts as shown below. Ensure
both the Total Gym logo and the warning
stickers are right side up. Install screws 1
and 2 first, then proceed to install the rest;
tighten completely.
Screw 1
Screw 2
D,C
D,C
See
close-up below
STEP 9.
Lay the Jump Trainer on its side.
Using the hardware (C, E) as indicated;
attach the Rear Struts / Incline Strut as
shown. Tighten completely.
NOTE:
Installing the screws in the order
shown may be easiest.
C
Close-up
E
1
6
3
7
5
2
8
4
See close-up below
STEP 10.
Turn the Jump Trainer upright
and, using the hardware (H, J, K, S) as
indicated; attach the Squat Stand to the
Struts. Tighten completely. Installing the
screws in the order shown may be easiest.
Once screws are fully tightened, push on
all 12 caps (S).
Plugs installed
at the factory
S,H,K
K,J,S
1
5
4
3
6
2
STEP 11. IMPORTANT: RETURN TO
STEPS 2-4 AND TIGHTEN ALL SCREWS
COMPLETELY.
