8
TOTAL GYM
®
JUMP TRAINER
TM
OWNER’S GUIDE |
ASSEMBLY & INSTALLATION
ASSEMBL
Y & INST
ALL
STEP 2.
Insert the Left Squat Strut on to
the Left Rail by positioning the bottom
of the Left Squat Strut in-between the
Left Rail and Bungee Panel (as shown in
close-up below). Gently wiggle the Strut all
the way on to the Rail until the holes are
aligned. Install the hardware (A, B, C, P) as
shown. Do not tighten completely.
See close-up
below
STEP 3.
Repeat STEP 2 on other side,
attaching the Right Squat Strut to the
Right Rail using the hardware (A, B, C, P)
as shown, but do not tighten completely.
See
close-up
below
Close-up
A
C
P
B
C
STEP 4.
Install the hardware (G, F) on both
rails as shown below.
G
F
F
G
DECIDE WHICH
INSTALLATION SETTING
IS APPROPRIATE FOR YOU:
PHYSICAL THERAPY OR
FITNESS.
Next, attach Front Base to holes 1, 2 and
3 as shown below using hardware (H,K,J)
as indicated. Make sure to install the
washer (K) on the bolt first (H). After all the
bolts and nuts are installed, tighten them
completely. Then cover each with a plastic
cap (M).
J
H,K
Hole 4 plugged
in Physical
Therapy Setting
Hole 3
Hole 2
Hole 1
This is how the Front Base attached to
the Struts should look for the PHYSICAL
THERAPY Setting.
Hole 4 plugged
in Physical
Therapy Setting
TO CONTINUE PHYSICAL
THERAPY ASSEMBLY
SKIP TO STEP 8.
A
C
P
B
C
Insure the Strut is
above the Bungee Panel
highlighted in blue.
Close-up
STEP 5. PHYSICAL THERAPY ASSEMBLY
FOR FITNESS ASSEMBLY SKIP TO STEP 6.
Using hardware (R), as indicated, first
insert plastic plugs into hole 4 on the
inside and outside of each Strut (as shown
below).
These holes
come already
plugged - do
not remove
Hole 4
PHYSICAL THERAPY
ASSEMBLY
