7 Connector Modules
The Advanced Cable Tester supports testing a large variety of cables via a system of
easily interchangeable modules. Each module is rated for 10,000 tests, guaranteeing
cost e
ff
ective and accurate cable test results.
7.1 Physically Installing Connector Modules
Connector modules are available in full-height and half-height sizes. When using half-
height connector modules, an included plate must be used to close o
ff
the module bay to
prevent accidental intrusions.
The sides of the module bay provides slots to guide and position the connector module
to ensure a proper and secure connection to the tester hardware. When installing the
module, ensure that the connector module PCB is lined up with the slot that is second
from the bottom as shown in
fi
gure 12. The top and bottom slots are designed to hold the
faceplate of the module securely in the module bay.
Figure 12
: Installing Connector Module
When installing the connector module, be sure to align the
PCB of the module with the second slot.
When installing the module, press the connector module in
fi
rmly until the module is
fl
ush
with the chassis. You will hear and feel a click when the module engages. The module
has retention features to ensure that the module remains
fi
rmly connected to the tester
while cables are tested.
Modules with a metal faceplate have quarter-turn fasteners. To secure the module once
seated in the tester, simply push the fasteners into the tester and turn it clock-wise until
they lock. To remove the module, simply turn the fasteners counter-clockwise until the
fasteners until the pop out. Once both fasteners have been unlocked, the module can be
removed by pulling on the fasteners.
Advanced Cable Tester v2 User Manual v2.0.0
29
