www.totalsheds.co.uk
© Sheds (Midlands) Limited 2021
STEP • 15
STEP • 14
Page 11
SIDE & CORNER STRIPS
Hide the panel edges.
Cover the framework & seams.
14a. Use all the side/corner strips to finish off the shed,
by covering any exposed framework and the panel
joining seams.
14b. Fix the strips down by using 3 screws to
secure them to the shed. This will create a nice
finish and hide any gaps on the outer walls of
framework, front, back and sides.
14c. Continue this process along the sides and
rear of the shed till you have covered all
exposed panel edges and seams.
PENT ROOF PANELS
Place 4x6ft roof section.
Repeat for larger models as shown.
15a. Place the 4x6ft roof section in
place. Repeat this stage for models
as shown below. 2ft roof section will
follow last. Shown in Step 16.
15b. Screw the roof panel down as
shown in Diagram 15b.
= Drill Points using
screws provided as shown
= Drill Points using
screws provided as shown
x6
4.0 x 70mm
x24
4.0 x 70mm
15b.
14b.
Repeat Steps for 4x6ft Roof
Panels as shown below:
8x6ft
10x6ft
12x6ft
14x6ft
16x6ft
18x6ft
20x6ft
Repeat
x1
Repeat
x1
Repeat
x2
Repeat
x3
Repeat
x3
Repeat
Repeat
x3
x4
DRILL
DRIVER
DRILL
DRIVER
