© Sheds (Midlands) Limited 2021
STEP • 5
SIDE & REAR PANELS
Fix 4ft Wide Blank Sections
Create Corner for Balance.
4a. Now place a blank 4ft panel side as shown. Create an ‘L’ Shape.
Repeat this step for all larger sheds. Please use reference on left for
additional sections required according to your shed size.
4b. Screw the panels at the framework as shown in Diagram 5b.
5b.
4b.
= Drill Points using
screws provided as shown
x3
4.0 x 70mm
Per Panel Edge
x3
4.0 x 70mm
Per Panel Edge
4FT BLANK PANEL
2FT BLANK PANEL
NOTE: Place panel to sit firmly
on the side Floor Block.
5a. Place the 4ft blank panel as shown along the
right end of the shed aligning with the edge of the
2ft panel and Floor Block. See Diagram 5a.
Use RED highlighted area as guide.
5b. It is advisable to have a
second person holding the
panel in place while the next
section is attached. You may
notice that the panels will have
nothing to balance on or againts
at this stage. It is advisable to use
supports if required at this stage
till the corner frames are
attached for balance.
5c. Screw the panels together as
shown on diagram 5c.
4ft RIGHT SIDE PANEL
Place blank 4ft panel against
right of shed floor as shown.
(4ft wide blank panel)
SHED FLOOR
5a.
IMPORTANT
Start
Build
point
from Left to Right.
As shown on the diagram.
NOTE: First 4ft Panel must sit firmly on floor block
4FT BLANK PANEL
Repeat Steps with 4ft Blank
Panels as shown below:
4c. DO NOT fix
the panels at this
stage to the floor
to leave room for
adjustments in
the final stages.
www.totalsheds.co.uk
STEP • 4
Page 6
8x6ft
10x6ft
12x6ft
14x6ft
16x6ft
18x6ft
20x6ft
Repeat
x1
Repeat
x1
Repeat
x2
Repeat
x3
Repeat
x3
Repeat
Repeat
x3
x4
4a.
5c.
DRILL
DRIVER
DRILL
DRIVER