Installation
a.1nstall the compressor in a vent
i1
ated place.
b.The space between the compressor and the w
a1
1 should be at least 50cm.
c.1nstallation of Motor:
l.
+H
you buy
WK
e motor yourself
please buy the same model
as the ai
r-
compressor
2.1nst
a1
1
WKH
as shown in the following diagram:
90
0
90
0
I
3.Adjust the belt to a proper degree of tightness in the way of pressing the middle
of the belt t
i11
it sinks for 10-15mm as shown in the following diagram:
4.1f the belt is too tight
the belt will be ove
r1
oaded and in consequence the axis
of the motor may eas
i1
y wear out
the motor may get heated
DQG
consume more power
and the belt may break down because of supe
r-
tension;
5.1f the belt is too loose
the belt may slip and in consequence it may cause a high-
heatabrasion of the belt
unsteady rotation of the air-compressor and inadequate
displacement.
Before sta
UWL
ng
a.Before starting the compressor be sure that
WK
e lube is enough.
It
is safe when
the lube level is at the red point of o
i1
glass. (Figure l)When necessary
add
WKH
lube
through the hole of the dipstick
Caution:
If
the lube is lower
WKDQ
the lower mark of the dipstick (Figure
1)
the
3