Note
：
A cold engine should be allowed to warm up at the idle position (c2) for
approximately one(1)minute
．
Failure to open the choke after the engine
attempts to start may cause flooding
．
CAUTION
：
Always open choke(b2)with throttle in idle position(c3)
．
Opening choke with
throttle not in idle position(c3)may result in rammer motion
．
Graphic 2
5.5 To Stop
See Graphic 2
5.5.1 Place throttle in the idle position (c3)
．
5.5.2 Turn engine switch to“OFF”(d)
．
5.5.3 Close fuel valve (e)
．
5.6 Low Oil Shutoff Switch (if equipped)
The low oil shutoff switch is designed to prevent engine damage caused by an
insufficient amount of oil
．
When starting the machine
：
●
if the warning light flashes quickly once
，
this indicates the engine oil level is
acceptable.
●
if the warning light flashes slowly
，
the engine will start but shut off after 10-12 seconds
，
this indicates that the engine oil level is low
．
Add oil to the engine
．
See Technical Data
18
Summary of Contents for TP880-1
