I
NTELLI
M
IST
H
UMIDIFIER
OUTPUT CHEC K
To check that all
the terminals are in proper working
order at the factory Carrier has created a test screen
located in the calibration mode of the Humidistat.
1. Push the 'on/off' button and the 'down' arrow until
all icons on the LCD screen are visible.
2. Now push the 'on/off' button once more.
3. The screen you are currently seeing is our test mode to
ensure proper wiring between the Humidistat and the
Humidifier. Push the 'flow' button to energize the
Intellimist Humidifier. Water droplets on the bottom left
hand corner of the screen will appear and the red LED
will energize. Push the 'flow' button once more to
deenergize the Intellimist Humidifier.
4. The screen you are now seeing is our test mode to ensure
proper wiring between the Humidistat and the Furnace
board, if your furnace is currently energized the
Humidistat will display an H in the upper right hand
corner of your screen. If the furnace is not energized a
dash will appear in the upper right hand corner of your
screen.
5. Push the 'on/off' button to exit the test screen and enter
into the normal operating screen.
Page 16
