Bike Assembly
The CS-260 ships fully assembled and ready to ride, with the exception of the pedals. The
CS-240 ships with the pedals installed. There are just a few simple steps to unboxing, pedal
installation, and some minor adjustments needed before you are on your way!
Step 1 – Remove All Packing Material
The Commuter Series bikes are packaged with tie wraps, rubber bands, foam inserts and
plastic gaskets to protect it in shipping. Carefully remove all this material and discard. Note
– the battery keys are attached to the center folding lock hinge OR the handlebars with a tie
wrap. Once complete, the bike will look like the image below:
Step 2 – CS-260 Pedal Installation
(Note - the CS-240 ships with the pedals installed) To install the pedals you will need a
15mm (or small adjustable) wrench. The pedals thread into the pedal crank holes. Note -
The right-side pedal threads into the hole in the clockwise direction, while the left side pedal
threads into the hole in the counterclockwise direction. Ensure that the pedals are threaded
in as far as possible and tight.
The pedals fold up for storage and transport. You will see a small oval-shaped hole on the
CS-260 with an arrow that when pulled allows the pedal to swing into the folded position.
TOTEMUSA CS-240/260
4