Step 3 – Raise Handlebar and Lock Into Position
Grab the handlebars, making sure they are free from the pedals, and pull them up into the
locking position. Secure the handlebars by pressing the lock level into place. The bars are
not locked until the knob on the right side of the level clicks into place. To unlock the
handlebars, press the knob on the right side of the lever down then pull on the lever to
release the lock and allow you to fold up the bar. See section 1.3 for recommendations for
proper handlebar height settings.
Step 4 – Adjust the Height and
Rotation of the Handlebars
Make sure the latch on the top of
the handlebars is open. Grab the
grip and rotate the bar so that the
reflector is facing forward and the
brake levers are in a comfortable
position. Close the latch on top
of the bar. If the latch is too difficult to close, slightly adjust the tension knob located
underneath the latch. Make sure that the latch closes very tightly so that the bar cannot
rotate. If the bar can be moved, open the latch, tighten the tension knob slightly, reclose
the latch and test again. Once the bar is secured, the height of the bar can be adjusted
using the latch located between the bar and the frame. See the next section for
recommendations for proper handlebar height settings.
Step 5 – Adjusting the Seat
Locate the latch under the seat and open. Slide the seat up to the desired height. Confirm
the seat is aligned properly with the frame then secure it in place by closing the latch. If the
pole is not securely locked in place with the latch, open the latch and adjust the tension
knob until the seat is completely immobile with the latch closed. See the next section for
recommendations for proper seat height settings.
TOTEMUSA CS-240/260
6
