7
totemacoustic.com
ConneCtions
Prior to making any connections make sure the power switch is set to OFF and the VOLuME dial is set to
its minimum value.
If connecting from a processor or preamp, connect using a pair of RCA interconnects from PRE-OuT (on
preamp and surround processors) or SuB-OuT (on surround sound processor) to LOW LEVEL In terminals
on the subwoofer. When connecting from a SuB-OuT on a surround sound processor only one interconnect
is required and can be used with LEFT or RIGHT LOW LEVEL in RCA terminals on the subwoofer.
Connect the power cord to the A.C. power inlet on the subwoofer and then directly to the A.C. receptacle
on the wall.
Note:
The
Dreamcatcher
is available in 120V and 230V operation. Make sure you have the correct unit
before connecting it to the A.C. supply.
POWER
ATTENTION:
UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE
ET CALIBRE
CAUTION:
FOR CONTINUOUS PROTECTION
AGAINST RISK OF FIRE, REPLACE
ONLY WITH SAME TYPE FUSE AND RATING
T1.0AL 250V
ON
1.0A 230V~ 50Hz
I N P U T
L E F T
1 8 0
0
RIGHT
P H A S E
F R E Q
V O L
50
80
150
MIN
MAX
0
0
R
!
WARNING: SHOCK HAZARD-DO NOT OPEN
NO USER SERVICEABLE PARTS INSIDE
AVIS: RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
Filename:Totem200SEuroPanelRevC.cdr
1 color: White
Silkscreen p/n: SLK2150
Revision: C
