10
11
Introduction
Safety Precautions
(Continued)
Operational Precautions
■
For prevention of damage
●
Wipe plastic areas such
as the top unit and
remote control with a
soft cloth tightly wrung
out with water.
Dry cloth or tissue
●
Do not lean against the
toilet lid.
■
Problem Prevention
●
Disconnect the power plug if there is a risk of lightning.
●
A toilet seat cover or a toilet lid cover cannot be used.
(The body sensors or seat switch may not function
properly.)
Covers
●
Do not urinate on the top unit, toilet seat or wand.
(Doing so may cause a failure or discoloration.)
●
Do not apply strong forces to the control panel of the
remote control.
●
When using a toilet cleaner to clean the toilet, wash it off
within 3 minutes and leave the toilet seat and toilet lid open.
Wipe off any cleaner that remains on the bowl unit.
(If vapor from a toilet cleaner enters the top unit, it may
cause a malfunction.)
●
Do not use the product with the toilet lid removed.
●
Do not expose to direct sunlight.
(Doing so may cause changes in color, irregular heated
seat temperature, remote control malfunction or NEOREST
malfunction due to the change in temperature.)
●
Use radios, etc. away from NEOREST.
(The product could cause interference with the radio signal.)
●
If you use a booster seat for infants or a soft highchair,
remove it after use.
(Keeping it installed may prevent some of the functions
from being used.)
●
Do not apply force to the remote control.
(May cause malfunction.)
To prevent the remote control from being dropped, set it
in the hanger when you are not using it.
Be careful not to expose it to water.
●
Do not place anything on the toilet seat and lid, and do
not press them with hands.
Failure to do so may turn on the seat switch, causing
the
fl
oor to get wet if buttons on the remote control are
touched and warm water comes out from the wand.
(The seat switch may turn on if force is applied to the
toilet seat or lid.)
■
For prevention of malfunctions
●
Do not block the body sensor or the remote control
transmitter or receiver.
<About the body sensors>
●
Body sensors detect a person standing in front of
the bowl unit.
Body sensors emit an infrared beam as shown in
the
fi
gures. When someone moves into the line of
this infrared beam, the sensor detects the person.
* Detection by the sensor may be dif
fi
cult when the
toilet is used by someone small, such as a child.
Body sensor A
Body sensor B
<About the seat switch>
●
When you sit on the toilet seat, the seat switch turns
ON, enabling you to use various features.
(A click sound is heard when the seat switch is
ACTIVATED.)
Seat switch
(Built-in)
Gap
The toilet seat lowers.
Switch
ON
●
Sit back on the toilet seat.
The seat switch will not turn on unless you
sit on the seat properly.
Note
When a child uses the product, the seat
switch may not be ACTIVATED by their light
body weight.
Since the toilet seat is designed to move up
and down, a clearance is provided between
the toilet seat cushion and the bowl unit.
Grounding Instructions
This product should be grounded. In the event of an electrical short circuit, grounding
reduces the risk of electric shock by providing an escape wire for the electrical
current.
The plug must be plugged into an outlet that is properly installed and grounded.
DANGER - Improper use of the grounding plug can result in a risk of electric
shock.
If repair or replacement of the cord or plug is necessary, do not connect the grounding
wire to either
fl
at-head terminal.
Check with a quali
fi
ed electrician or serviceman if the grounding wire instructions
are not completely understood, or if in doubt as to whether the product is properly
grounded.
This product is factory equipped with a speci
fi
c electric cord and plug to permit
connection to a proper electric circuit. Make sure that the product is connected to an
outlet having the same con
fi
guration as the plug.
No adapter should be used with this product. Do not modify the plug provided - if it
will not
fi
t in the outlet, have the proper outlet installed by a quali
fi
ed electrician.
If the product must be reconnected for use on a different type of electric circuit, the
reconnection should be made by quali
fi
ed service personnel.
If it is necessary to use an extension cord, use only a three wire extension cord that
has a three blade grounding plug, and a three-slot receptacle outlet that will accept
the plug on the product.
Replace or repair a damaged cord.
Grounding pin
SAVE THESE INSTRUCTIONS
Operation
