Toto NEOREST AC SN996MX CWT996CEMFX, Instruction Manual

14

15

Introduction

Preparation

Using the Product for the First Time

If the remote control is secured 
(for anti theft)

1

Remove the screws (2, left 
and right) from the remote 
control 

fi

 xture.

(View from side)

Remove

Remote control

Phillips screwdriver
(Fine-tip type)

Screw
(2 pieces, left 
and right)

Hanger

Wall

2

Remove the remote control 
from the hanger.

Remote 
control

Hanger

Wall

■

To secure the remote control again

Tighten and 

fi

 x the screws (2, left and right).

(Overtightening may cause damage to parts 
such as the hanger.)

1. Insert the battery

1

Remove the remote control 
from the hanger.

Remote control

Hanger

2

Open the battery cover and 
insert two AA batteries.

Close

Open

Battery cover

●

When batteries are properly inserted, 
temperature levels appear on the display of 
the remote control (back side).

●

The display goes out when no button on 
the remote control is pressed for about 60 
seconds or more.

WATER TEMP
SEAT TEMP
DRYER TEMP

3

Mount the remote control in 
the hanger.

■

About the batteries



Use dry cell, alkaline batteries.



Be sure to follow "Safety Precautions" to revent the 
batteries from rupturing or leaking 

fl

 uid. (Pages 6, 8)

2. Turn on the power

1

Remove the side panel and 
insert the power plug.



The wand extends and then retracts.

Side panel (right)

Loosen the bottom screw of the side panel (right) 
with a flat-head screwdriver, pull the side-panel 
diagonally upward, and then pull it out downward.

Screw

(2)
Pull up

(3)
Pull out

(1)Loosen

 •

Both side panels can be removed or installed in the 
same way.

 •

Dropping the side panels may cause damage.

2

Check that the [POWER] LED 
on the main display is lit up.



If the LED on the main display is not lit up, 
pressing [POWER ON/OFF] will light it up.

3

Reinstall the side panel.

(2)  Keep it aligned with the 

reference line for panel 
installation.

(2)

(1)

(3)

(3)  Tighten

(1)  Fit it in from 

below at an 
angle.

Reference line for 
panel installation

Keep the side panel (right) aligned with the reference line for panel 
installation, and then tighten the bottom screw with a 

fl

 at-head screwdriver.

To turn the power "OFF"

Press [POWER ON/OFF] to 
turn the power off.



The POWER LED goes off.

3. Open the shutoff valve

1

Fully open the shutoff valve.



The shutoff valve is located in the side panel (left).
(Refer to the above for removal and installation.)

Side panel (left)

Operation