Toto PJY1724PW, Installation Manual

7

Building of ceramic tile

●  

Drop-in Installation

 a. Bathtub without skirt: Build a low wall with brick. Build ceramic tile on the outer 

side of the low wall with mortar (a clearance of at least 3/16”(5mm) is kept between    

the upper edge surface and bathtub side). Buffer material is used to fill this clearance (such as soft polythene or 

equiva lent material). At last sealing material is used to seal the clearance between ceramic tile and bathtub. 

(Refer to the following Figure B). 

A Wall edge

B

1. During the whole installation soft material is recommend to cover bathtub surface to 

prevent surface scratching.

2. The bathtub cannot be hung by the rim. The bathtub weight must be transferred solely

    through its feet.

3. During installation, do not allow the bathtub to collide with hard objects and do not

    allow hard objects to fall into the bathtub.

4. The back of bathtub can not be filled or buried by mortar otherwise damage may be

    caused.

5. During construction, never stand on the bathtub or place heavy material on the

    rim of the bathtub. This may damage the bathtub.

Note: After installation of the bathtub clean the floor. Then use a sponge or cloth

          with neutral detergent to clean the bathtub. After 5 minutes, rinse with water

          and then wipe dry.

Warning

Drop-in Installation

Material for 

stopping mortar 

(sponge etc.)

3/16”(5mm)

Sealed material 

Tile

Mortar 

Brick 

13/16”

(20mm)

20