■
For prevention of malfunctions and failures
●
Disconnect the power plug if there is a risk of
lightning.
●
A toilet seat cover or a toilet
lid cover cannot be used.
(The seat switch may
not function properly.
Additionally, the toilet seat
and lid may not open or
close properly.)
●
Do not urinate on the main unit, toilet seat or wand.
(Doing so may cause a failure or discoloration.)
●
Do not apply strong forces to the control panel of
the remote control.
●
When using a toilet cleaner to clean the toilet, rinse
it off within 3 minutes and leave the toilet seat and
toilet lid open.
(If vapor from a toilet cleaner enters the main unit,
it may cause a malfunction.)
•
Wipe off any cleaner that remains on the bowl unit.
●
Do not use the product with the toilet lid removed.
●
Do not expose to direct sunlight.
(Doing so may cause changes in color, irregular
heated seat temperature, remote control
malfunction or the product malfunction due to the
change in temperature.)
●
Use radios, etc. away from the product.
(The product could cause interference with the
radio signal.)
●
If you use a booster seat for infants or a soft
highchair, remove it after use.
(Keeping it installed may prevent some of the
functions from being used.)
●
Do not apply force to the remote control.
(This may cause a malfunction.)
•
To prevent the remote control from being
dropped, set it in the hanger when you are not
using it. Be careful not to expose it to water.
●
Do not place anything on the toilet seat and lid,
and do not press them with hands.
(Failure to do so may turn on the seat switch,
causing the floor to get wet if buttons on the
remote control are touched and warm water
comes out from the wand.)
■
For prevention of malfunctions
●
Do not block the remote control transmitter or
receiver.
<About the seat switch>
●
When you sit on the toilet seat, the seat switch
turns ON, enabling you to use various features.
(A click sound is heard when the seat switch is
ACTIVATED.)
Seat switch (Built-in)
The toilet seat lowers.
Switch
ON
Gap
●
Sit back on the toilet seat.
•
The seat switch will not turn on unless you
sit on the seat properly.
Note
•
When a child uses the product, the seat
switch may not be ACTIVATED by their
light body weight.
•
Since the toilet seat is designed to move
up and down, a clearance is provided
between the toilet seat cushion and the
bowl unit.
Covers
■
For prevention of damage
●
Wipe plastic areas such as the main unit and remote
control with a soft cloth tightly wrung out with water.
Dry cloth or tissue
●
Do not lean against the toilet lid.
Operational Precautions
11
Introduction
Delete
『●This product is intended for use up to a maximum
height of 6,562 ft (2,000 m) above sea level.』
Due to the requirements of the IEC standard,
it was not applicable to the United States.
corrected
