– 28 –
<Viewed from Connector Surface>
10-2. Auto Cutter Specifications
(1) Cutting Modes
Partial cut (leaves one uncut portion in center of paper)
(2) Cutting Duty
Min. 3 seconds/cut
(3) Thickness of paper
0.065 ~ 0.085 mm
10-3. Interface
RS-232C serial interface / Two-way parallel interface (IEEE1284)
10-4. Electrical Characteristics (AC adapter)
(1) Input:
100 to 240 V AC, 50/60 Hz
(2) Output:
DC 24 V ± 5%
(3) Current Consumption (DC 24 V at room temperature)
Standby:
Approx. 0.15 A
ASCII printing:
Approx. average 1.7 A
(Approx. 17.5% printing rate)
100% print duty:
Approx. peak 9.0 A
(Solid printing):
Approx. average 5.0 A
(Continuous solid printing should be 10 seconds or less.)
(4) Power Connector
Pin No.
Function
1
Drive power (24 V)
2
Signal GND
3
N.C.
Shell
Frame ground
Note:
• When using a printer power supply other than the optional AC adapter (PS60A-24A
series), be sure that the following cautions are observed.
• Use a power supply of DC 24 V ± 5% and more than 2.0 A (5.0 A Load 10 sec. Min.)
with SELV output and LPS or Class 2 output approved by IEC60950.
• Be careful about installing the printer in an area where there is noise. Take the appropri-
ate measures to protect against electrostatic AC line noise, etc.
