- 13 -
The following accessories are necessary when mounting the printer to a wall.
• Holding plate and two screws
4-1. Attaching the Holder Plate
■
The holder plate is attached to the printer using the included screws and is hooked onto screws that are
installed into the wall.
■
The screws on the wall are not included.
Use commercially available screws (4 mm diameter) that are suitable for the wall material (wood, steel
beam, concrete, etc.).
■
The printer’s weight is approximately 2.4 kg when the largest diameter roll paper is loaded.
Use screws on the wall that have both shear strength and pulling-out strength to withstand a force of at
least 12 kgf (118 N).
Precautions regarding installation
CAUTION
This caution indicates information that, if ignored, could lead to
personal injury or property damage.
• Be sure to have qualified personnel install the specified screws and printer to the wall.
Star is not responsible for any accidents or injuries that occur as a result of improper in-
stallation, misuse, or modifications.
Especially when installing the printer at a high location, make sure that the printer is se-
curely installed to the wall.
If the printer is not installed securely and falls, personal injury or damage to the printer
may result.
• Make sure that the mounting surface and installation screws are strong enough to install
the printer.
Securely install the printer so that the weight of the printer and any connected cables will
not cause the printer to fall.
Otherwise, personal injury or damage to the printer may result.
• Do not install the printer in an unstable location or a location that is exposed to vibration
and shocks.
If the printer falls, personal injury or damage to the printer may result.
(1) Remove the rubber feet from the printer unit.
4. Attaching the Accessories
