Care and Maintenance
35
Po
ly
Vis
ion
®
Use the care instructions below if your board’s serial number begins with
“A” or “B”:
•
Wipe the whiteboard with a clean, soft, dry cloth or a duster.
•
Clean whiteboard parts with a cloth dampened with mild soap and
water. Stubborn stains can be removed using isopropyl alcohol.
•
Do not use spray cleaners (such as whiteboard cleaner). Spray cleaners
will damage the board.
•
Do not use abrasive cleaners or cloths.
Use the care instructions below if your board’s serial number begins with
any other letter:
•
For daily cleaning or as needed, rinse surfaces with water using a soft
cloth or sponge. Dry with a soft cloth prior to writing.
•
Remove any remaining marks with Sanford Expo Towelettes or
equivalent. Whiteboard cleaners available from PolyVision or at office
supply stores can also be used.
•
Important!
Always rinse with water and dry with a soft cloth to prevent
future markers from smearing.
•
For stubborn stains, you can use a paint/stain remover such as Goof
Off
®
. After the stain has been removed, rinse with clean water and dry
with a soft cloth.
For all TS and TSL whiteboards:
•
Use only the dry-erase markers and erasers recommended by
PolyVision. To order markers, call 1.800.620.POLY (7659) in the USA,
1.678.542.3100 outside the USA, or +32 (0)89 32 31 30 in Europe, or
go to:
•
www.polyvision.com
•
Change erasers when they become dirty to leave less ink residue on
your board. Replacement erasers are available directly from PolyVision.
Call 1.800.620.POLY (7659) in the USA, 1.678.542.3100 outside the
USA, or +32 (0)89 32 31 30 in Europe, or go to:
•
www.polyvision.com
•
Do not use ballpoint pens or other pointed instruments on the surface.
•
Do not use abrasive cleaners on the surface.
•
To erase pen strokes made with permanent markers, write over the
marks with a dry-erase marker of the same or similar color, then erase.
PolyVision I&O.book Page 35 Thursday, October 16, 2008 4:18 PM
