20
Installing the Ovation Jukebox
3. Adjust the wire-strain relief bracket until both of the following conditions are met:
• The bracket presses against and holding all of the cables coming into the jukebox through
the cable channel to maintain slack for each cable.
• The bracket partially closes the cable channel opening to the jukebox to prevent dust from
entering the Ovation.
4. Tighten the screws for the wire-strain relief bracket to hold the bracket in position.
Turn on power to the MJS
You turn on power to the MJS in the Ovation so you can activate the jukebox and configure its
settings.
To turn on power to the MJS:
• Turn the MJS system power switch to ON.
The MJS in the jukebox powers up, checks the jukebox hardware components and then
begins loading its system software.
Figure 15
Adjusting the wire strain-
relief bracket to close the
cable channel
Rad
ic
om®
US
B M
od
em
to USB
Modem
to Audio
Out
to Power
Recepticle
Area Enlarged
Summary of Contents for Gem3 Ovation
Page 1: ......
Page 42: ...36 Activating the Jukebox...