Virtuo Installation and Setup Guide
Installing Virtuo
Connecting Audio Speakers to Virtuo
60
Connecting Audio Speakers to Virtuo
Virtuo does not include internally mounted speakers. To connect external speakers to Virtuo’s amplifier, you must
use the 4-pin Euroblock connector (part no. 100000-001).
To connect audio speakers to Virtuo
1.
Prepare the speaker wires by stripping the ends of the 4 connector wires, exposing approximately 1/4” of wire.
2.
Locate the supplied four-slot Euroblock connector.
3.
Loosen the screws along the top of the connector using a flat-head screwdriver, if necessary.
Euroblock terminals
4.
Wire the ends of the speaker wires to the Euroblock connector using this figure as a guide.
Speaker Wiring
CAUTION
: Virtuo’s amplifier is specifically designed for use with 4-ohm speakers.
Using speakers of a lower impedance is not recommended. If 8-ohm speakers are to
be used, they must be wired in parallel in order to enable the amplifier to provide its full
power. If 8-ohm speakers are connected directly to the amplifier, only half the power is
available.
CAUTION
: Bose model 141 speakers will not function with Virtuo’s amplifier. Do not
attempt connection of these speakers.
Similarly, wiring two pairs of Bose model 301 speakers
in parallel
can result in
unsatisfactory performance.
Overhead view