Setting up your Virtuo
Connecting a Microphone
Virtuo Installation and Setup Guide
95
3.
Loosen the screws along the top of the connector using a flat-head screwdriver, if necessary.
Euroblock terminals
4.
Wire the ends of the 4 microphone wires to the Euroblock connector using the legend on the DI box’s label as a
guide.
Wiring legend
5.
Refer to the manufacturer’s documentation for your microphone to determine color coding and wiring information.
6.
Using a flat-head screwdriver, tighten the screws of the slots for the microphone to secure the speaker cable to
the connector.
7. Attach the Euroblock connector to the connector labelled
MIC IN on the MIC box.
8.
Connect one end of a Cat 5 cable to the RJ45 output connector labelled
TO PC MIC INPUT
on the MIC box.
9.
Open either of the cable access ports on the rear of Virtuo.
10. Route the cable through the cable channel on the rear of the cabinet and then into Virtuo.
11. Plug the other end of the Cat 5 cable into the port labeled
MIC 1
or
MIC 2
on the I/O board.
12. Close the cable access channel.
Overhead view