©2013
ToughJets,
LLC
Kittery,
ME
Page
10
of 22
Epoxy 2 dowels into the flutes of each
vertical stabilizers. Position the dowels
1
”
and 4
3/8
” from the trailing edge. Leave
about 1 ½” of dowel exposed
Use alignment tool to
open
Vertical
stabilizer dowel holes to
poke hole in
foam
for dowels
press tool flush with top of
wing insert sharp dowel into foam.
Repeat steps for other side. It’s starting to
look like a plane now.
insert stabilizer dowels matching the
same angle set by alignment tool it
should be a tight fit not needing glue,
remaining removable for
transporting.
,