TOUGH-WORKS TLGS625, Instruction Manual

12

BD4603

TLGS625

in the belt.

OPERA

TION  

The 2 in. sanding belt on the machine works great 

for non-ferrous metals and wood products. A wide 

variety of belts are also available for many types 

of materials and stages of finishing.
To sand a workpiece:

1. Before starting the machine, adjust the angle 

    of the tool rest so your workpiece is supported 

    and the area you wish to sand is parallel with

    the sanding belt as illustrated 

（

in Fig 7

）

.

2. With the machine plugged into power, stand 

    to the side of the grinding wheel and move 

    the red switch to the ON position. 

Figure 7

3. Allow the machine to run for at least 1 full mi-

    nute to make sure that the grinding wheel is  

    not going to fly apart and injure you, then move 

    to the front of the machine.

4. Grasp the workpiece tightly and properly 

    support it on the tool rest.

5. Press the workpiece evenly against the sa-

    nding belt with light pressure (see Fig 8 and 9). 

    DO NOT press hard. Let the rotation of the

    belt do the work.

6. Remove your workpiece regularly to check 

    the progress the sander has made. 

    Remember you can always remove more 

    material but you cannot add it.

7. When you are finished sanding, move the red 

    switch to the OFF position. DO NOT continue 

    sanding and DO NOT manually stop the san-

    ding belt with your workpiece.

Figure 8

Figure 9