TOUGH-WORKS TLGS625, Instruction Manual

ELECTRICAL SAFETY

BD4603

5

TLGS625

A separate electrical circuit should be used for your 

machines. This circuit should not be less than #12 

 fuse. If an extension cord is used, use only 3-wire

 extension cords which have 3-pronged grounding

type plugs and matching receptacle which will 

accept the machine’s plug. Before connecting the  

machine to the power line, make sure the switch

 is in the "OFF" position and be sure that the ele-

 ctric current is of the same characteristics as 

indicated on the machine. All line connections 

should make good contact. Running on low voltage 

wire and should be protected with a 20-A time-lag 

will damage the machine.

GROUNDED 

OUTLET BOX

CURRENT 

CARRYING 

PRONGS

GROUNDING BLADE 

IS LONGEST OF THE 3 BLADES

GROUNDED OUTLET

BOX

GROUNDING 

MEANS

ADAPTER

Figure. 1

Figure. 2

MOTOR SPECIFICATIONS

Your machine is wired for 120 V, 60Hz 

alternating current. Before connecting the 

machine to the power source, make sure 

the switch is in the "OFF" position.

GROUNDING INSTRUCTIONS

!

DANGER!

DO NOT EXPOSE THE MACHINE TO RAIN OR 

OPERATE THE MACHINE IN DAMP LOCATIONS.
THIS MACHINE MUST BE GROUNDED 

WHILE IN USE TO PROTECT THE OPERATOR 

All grounded, cord-connected machines: In the 

event of a malfunction or breakdown,grounding 

provides a path of least resistance for electric

current to reduce the risk of electric shock. This 

machine is equipped with an electric cord having 

an equipment grounding conductor and a gro-

unding plug.

FROM ELECTRIC SHOCK.    

The plug must be plugged into a matching outlet 

that is properly installed and grounded in accor-

dance with all local codes and ordinances.

Do not modify the plug provided–if it will not fit 

the outlet, have the proper outlet installed by a 

qualified electrician.

Improper connection of the equipment-grounding

conductor can result in risk of electric shock. The 

conductor with insulation having an outer surface 

that is green with or without yellow stripes is the 

equipment-grounding conductor. If repair or repl-

acement of the electric cord or plug is necessary,

do not connect the equipment-grounding condu-

ctor to a live terminal.

Check with a qualified electrician or service per-

sonnel if the grounding instructions are not com-

pletely understood, or if in doubt as to whether the 

machine is properly grounded.

Use only 3-wire extension cords that have 3-pronged 

grounding type plugs and matching 3-conductor 

receptacles that accept the machine’s plug, as shown

in Fig. A.Repair or replace damaged or worn cord

immediately.