tousek
/ EN_REX-Force_01 / 25. 03. 2020
- 19 -
2.6
Programming
REX Force
–
ESC
ENTER
+
text display
The different menu points are indicated as follows:
= selectable settings
= factory settings
= status display
G
shows the menu points which are in the “ BASIC SETTINGS”
•
The program menu is divided into „POSITIONING“ „BASIC SETTINGS” and „ MENU CONTROL”
G
Positioning
Automatic:
the final positions are determined automatically, i.e. the positions, where the gate gets stopped by the
mechanical stops, are learned as final positions.
Manually:
the gate is manually brought to the desired OPEN and CLOSED position. These two positions are confirmed
as end positions by giving an impulse (radio, button).
The selection of the positioning mode (automatically or manually) takes place at the beginning of the programming process.
Afterwards this menu point gets hidden and can be selected either by resetting to factory settings or by deleting positions.
BASIC SETTINGS
•
When entering the programming of the control unit for the first time you will see the BASIC SETTINGS after
POSITIONING
.
(
see page 36).
• Here the necessary adjustments for the use of the operator/gate can be set quickly.
• For advanced settings/programming please choose the menu point „menu control”.
MENU CONTROL
• For futher programming you will reach immediatly the MENU (CONTROL) (Basis settings are skipped)
• The menu control includes all kinds of settings.
Programming menu
Adjustments - overview
Programming buttons
Adjustments - overview
•
The adjustment (programming) of the operating parameters is carried out with four programming buttons and
the display.
•
Before starting the programming, please choose the language. Use the buttons
+
or
-
to choose menu langua-
ge and confirm with
ENTER.
• Note: Language selection can also be chosen by pressing the ESC button for 5s, from any position in menu
.
• The text display informs about behaviour, chosen menus
and adjustment of different settings.
• The programming of the control is carried out with the help
of four buttons
(+, -, ENTER und ESC).
• Scrolling through the available menu points (up/
down) or the adjustment of a parameter (value in-
crease/decrease) is carried out with buttons
+
and
–
..
AUTO-COUNT:
when holding one of the buttons the value
changes automatically.
• When pressing the
ENTER
-button a confirmation for
entering the shown menu point, resp. for accepting the
shown value of a parameter is given.
• When pressing the
ESC
-button you return to the superior
menu point. Possibly changed adjustments of a parameter
are rejected with this button (the former values will remain).
•
AUTO-EXIT:
if no button is pressed during 1 min. then the menu switches automatically to the “ready” menu (wihtout
saving changed parameters)
