- 4 -
tousek
/ EN_TPS-60-PRO_05 / 25. 03. 2020
1. General
Sliding gate operator TPS 60 PRO
Technical data
Schiebetorantrieb TPS 60 PRO
Control unit
integrated
Max. drive
60m
Power supply
400V a.c., 50Hz
Duty cycle in
S3 mode
80%
Motor voltage
400V a.c.
Max. current consumption(excl. equipment)
5A
Ambient temperature
-20°C +50°C
Gear wheel, head circle diameter
Z17m6, Ø 114mm
Protection class
IP44
Max. gate weight
6000kg
Torque sensor
Speed
9m/min
Article No.
11110700
Torque
300Nm
optional erhältliche Komponenten
plug-in radio receiver • additional modules for courtyard / control lamp • radio transmission
system TX 310 • inductive signal transmission system TX 400i
An all-current sensitive FI circuit breaker (Type B) is necessary for proper operation!
Characteristics
TPS 60 PRO
Motor and central unit housed in a column and
pre-wired
Integrated central unit with frequency converter
Base housing made of brushed stainless steel
Cover made of aluminum, powder coated
Cover with profile half cylinder
Large, illuminated LCD display (2x16 characters)
Clear text menu programmable via four buttons
Operation mode is selectable
(Impulse, Automatic, Deadman)
Free adjustable partial opening for pedestrians or
car/truck function
Distance measurement made via speed sensor
(mit Positionierungsendschalter)
Height adjustment gear wheel (center): 193 ± 20mm
Gear wheel Z17 module 6
Adjustable soft stop (distance and speed)
Due to use of a frequency converter no power loss
also by reduced speed
Direct connection of 8.2 kOhm contact strips separate
for main and side closing edge
Status display for safety and push button inputs
Self-monitoring of photocell
Gate status display (for example, concierge)
Slots for radio receiver and I-loop detector
Integrated main switch and 230V Schuko socket
Optional height-adjustable fork and bracket for signal
transmission system
Dimension (W x H x D):
520 x 1365 x 230mm
(+ Gear wheel 60mm)
Function
TPS 60 PRO
The integrated control unit can be adjusted in 3 logic modes:
a) Impulse mode:
with open and close button/switch function
b) Automatic mode: automatic closing
c) Dead-man mode: gates moves as long as switch/button is pressed
With the connection possibility of buttons OPEN/CLOSE/STOP, photocells and entrance protection as well as switch for pe-
destrian entry. This one opens the gate partially. The partial opening is adjustable (opening time adjustable). For control of a
light signal a 230V output is available for connection of a signal lamp as well as two potential free signal contacts. The control
board is also equipped with connection slots for a radio receiver board as well as induction loop detector.
ATTENTION !
• ATTENTION: Mechanical limits are necessary!
• ATTENTION: the sliding gate operator has been developed and designed for the automation of horizontally
travelling sliding gates. Gates on sloping tracks (i.e. gates which follow an inclined, non-horizontal, travel
path) must not be automated without additional safety devices (which make sure that the gate cannot start
moving on its own from any gate position).