Tower Hobbies BMT131000BLG, Safety And Instruction Manual

9

Using the Window Vacuum:

1.  Once the window vacuum has been assembled, press the On/Off button to 

turn it on. The motor will start up and the LED indicator light on the lower part 

of the unit will light up blue to indicate the unit has been turned on.

2.  Press the On/Off button again while the unit is in operation to turn it off. The 

motor will stop working and the LED indicator light on the lower part of the 

unit will go out to indicate the unit has been turned off.

3.  To use the vacuum cleaner, turn it on and run it over the area to be cleaned 

in a straight line, from top to bottom or from side to side. The vacuum will 

automatically absorb any water or moisture contained within that area and 

store it in the water tank. Repeat this process as many times as necessary until 

the relevant area has been fully cleaned.

Using the Spray Bottle:

1.  This unit comes complete with a spray bottle, which can be filled with water or 

a soft, non-abrasive detergent to clean windows or glass surfaces.

2.  To fill this bottle, unscrew the spray nozzle and put it to one side. Fill the bottle 

with water, replace the spray nozzle and turn it clockwise to tighten it and 

secure it into place.

3.  To use the spray bottle, press the trigger on the nozzle. Water will spray out 

onto the surface to be cleaned.

Using the Cloth Head Attachment:

1.  This unit comes complete with a cloth head attachment and microfibre cloth 

attachment, for use with the included spray bottle.

2.  To use the cloth head attachment, begin by attaching it to the spray bottle. 

To do this, remove the spray nozzle from the bottle and thread it through the 

opening at the front of the cloth head attachment until it sits flush inside it. 

3.  Once the nozzle is securely positioned inside the opening, gently press the 

two tabs on either side inwards and fit the nozzle into the securing ring. The 

securing ring is correctly installed when the protruding part is aligned with the 

back part of the cloth head attachment. If the two parts are correctly aligned, 

they will automatically click into place.

4.  Once the cloth head attachment is correctly installed, fit the microfibre cloth 

over the top of it using the included straps and Velcro pad.

5.  The cloth head attachment is now ready for normal use.

Note:

 Ensure the spray bottle has been filled with water before attempting to use 

the cloth head attachment.

6.  To use the cloth head attachment, begin by spraying water onto the surface 

to be cleaned, as described in the ‘Using the Spray Bottle’ section above. Once 

the surface is wet, run the cloth head attachment over the areas to be cleaned, 

as required. Once the surface has been cleaned, use the main unit to dry out 

the affected areas if necessary.