Tower Hobbies NO GRAVITY, User Manual

5.Install fuselage foam block into slot that shown in above picture, then fix with glue. 

6.Attach rudder onto the rear fuselage according to their corresponding cuttings
   and fix with glue. Make sure the rudder is on the same level as fuselage.

7.Insert left and right wing fences into slots on wing, make sure they’re perpendicular 
   to wing, then fix with glue. 

8.Install wing bracing rod 1 and 2 on corresponding places on wing and fuselage, 
   after make sure wing and fuselage is perpendicular to each other, fix the bracings 
   with glue. 

9.Install elevator bracings as picture shown. Make sure fuselage and elevator is 
   perpendicular to each other, then fix the bracings with glue. 

9.1.Place adjustors into holes on servo arm, and fix them with nuts both upside 
        and downside. Befor adding glue on joints between servo arm and nuts, 
        make sure adjustors are in function. 
9.2.Pass the servo wires through the servo house as picture shown. 
9.3.Fix the assembled servo arm onto servo with screw. 
9.4.Put this servo which will be used for vector system into the servo house, then 
       fix with glue.

NO GRAVITY