8
❏
3. Use CA to glue the control horn in the slot with the quick
connector towards the wing root.
❏
4. Use a sharp hobby knife to cut the fl ap servo opening.
The foam over the opening is approximately ¼” (6mm) thick.
❏
5. To assist in pulling the fl ap servo leads through the
wing, tie a small nut (not included) to a string.
❏
6. Insert the nut in the opening in the fl ap servo recess.
Gently shake the wing to guide the nut and string to the
opening in the top center of the wing.
❏
7. Attach the fl ap servo lead to the string and carefully
pull it through the wing and out of the opening. Tip: Tie the
string to the retract cable and use a piece of masking tape
to position the string at the end of the connector.
❏
8. Connect a Y-harness to the fl ap servo lead.
❏
9. Plug the fl ap servo into the fl ap channel on the receiver.
Switch on the transmitter and then receiver. Check that the
servo arm is as shown with the fl ap control on the transmitter
set to fl aps up.
