4
PREPARATION
❏
1. The canopy hatch is removed by pushing the hatch
forward to disengage the magnets and tabs, then lifting the
back of the hatch upward and pulling the canopy back and out.
❏
2. Use a covering iron with a protective cover sock to
remove any wrinkles or areas of loose covering that may have
developed after the covering was originally applied. Start
with low or medium heat to fi nd the setting that works best
(approximately 300º F measured on the surface of the cover
sock). Gradually increase the heat as necessary to get the
covering to tighten. Too much heat may cause seams and
edges to pull away or damage the color graphics printed onto
the covering. As you proceed, push down on the iron over
sheeted areas to bond the covering to the wood underneath.
KIT CONTENTS
SPARE PARTS
1. Cowl
2. Canopy Hatch
3. Fuselage
4. Right Wing
5. Left Wing
6. Horizontal Stabilizer
7. Wing Fairing
8. Vertical Stabilizer
9. Wing Joiners
10. Wheel Pants
11. Wheels
12. Landing Gear Wires
13. Spinner
14. Plastic Hardware
15. Metal Hardware
16. Pushrods
TOWA4100
Wing Set
TOWA4101
Fuselage
TOWA4102 Tail Surfaces Set
TOWA4103
Cowl
TOWA4104
Hatch
TOWA4105 Landing Gear Set
TOWA4106 Wheel Pants Set
TOWA4107
Decals
GPMA4045
1-3/4" White
Spinner
15
16
1
11
6
2
12
13
14
4
8
9
10
7
3
5